JAE Gas Outrigger V2
The JAE outrigger was designed and developed as a result of a joint venture between
IMPBA Hall of Fame member Rod Geraghty, along with David Hall, Ron Zaker Jr. & Martin Truex Jr.
The main difference between this hull and all the others is the use of sharp angles on the bottom
of the sponsons and tub, as opposed to curved surfaces.
This helps break any surface tension of the water and makes for a faster boat.
This design approach has been built, developed and tested a great deal.
We don't recommend this as your first boat, as it can easily exceed 70 mph with a stock engine.
However, if you are an experienced boater, this would make an excellent first wood kit.
Also available as a Pre-Built kit from Walker Custom Boats
This is the Version 2 kit. It has many small updates to make it easier to build and easier to setup.
Full kit includes: All CNC cut Birch ply for kit Pre cut foam sponson cores Aluminum boom tubes Aluminum sponson plugs 5/8 ID Aluminum Boom Tube CollarsStainless sponson attachment hardware 6061 aluminum turn fin Stainless turn fin mounting hardware Servo mounts Fuel bag mount Carb spray shield kitPhoto illustrated step by step building and setup manual
Requires: Gas engine w/ 5 inch mounts (Zenoah, Quickdraw) Cowling (see our 2404 cowling)2 channel radio with 2 servos (one high torque servo (100+ oz/in)) 250-500 ml IV bag and tubing Strut and rudder 1/4x24 inch flex shaft Engine collet Drive dog 2818/2 or 1667/2 prop Prop nuts Glue, paint and finishing materials
Our 3605-U Ultimate Hardware Set includes everything neded (less engine and radio)
Specs: Length- 41 inches Beam- 25.5 inches Weight (RTR) 10-12 pounds
This product was added to our catalog on Monday 21 March, 2011.