Super Sport Carb Shield Set

This is the factory carb shield set 3D printed for you.

Made from tough PETG material, this carb shield will prevent water spray from getting to the carb.

You can race close and tight, without worrying about another boat spraying you down.

Helps keep you going in rough water as well.

Water, even a fine mist, can wash away oil and lead to immediate piston and cylinder damage.

This shield minimizes that.

Allows you to choke the carb with your finger as well.

Includes:

PETG Carb Shield
PETG Nut Plate
1/4-20 Nylon Bolt

To install-
Just put the shield where you want it, drill a 1/4 inch hole thru the deck and shield flange.

Then glue the nut to the bottom of the flange (CA or epoxy).

Seal the hole in the deck.

Put the shield in place and tighten the nylon screw.

Choose Color...