Featured Products

1/4 x 27 inch flex shaft. Has 1/4 stub shaft welded on. Stub shaft is 3-1/2 inches long. 1 inch shorter than normal. Designed for use with ... See Options

Sullivan aluminum ball connector w/sleeve. Use as a pushrod end where you need some angular movement. This assembly allows slop-free movement and ... See Options

Aluminum ball connector w/sleeve. Use as a pushrod end where you need some angular movement. This assembly allows slop-free movement and easy ... See Options

CNC machined aluminum switch mount with switch included! This switch mount is machined from 6061 billet aluminum, then anodized. Simply drill a 3/16 ... See Options

Bullet prop tail nut for 1/4 inch shafts. Not actually a nut, but has a 1/4 inch hole with a set screw. Hole depth is a little over 1/2 inch. Bullet ... See Options

Deluxe O-ring style cowl hold down set. Attach one standoff to the cowling, and one on the hull. The O-ring stretches between them to retain the ... See Options

Dual Servo mount for two standard size servos in tandem. Bolt to floor or side. CNC machined from billet 6061 aluminum and clear anodized. ... See Options

Extra Large fin for transom left side mounting on large mono hulls 40 inches and larger. measures about 4-1/2 inches tall, and just under 2 inches ... See Options

New long aluminum boom tube sleeves for 5/16 and 8mm boom tubes. These sleeves get glued into the sponsons and accept the carbon boom tubes. Replaces ... See Options

Micro balloons for use as a lightweight filler to build epoxy thickness. Very easy to sand once cured. Light weight and easy to use. Simply add to ... See Options