Super Digital Standard Servo

NEW! High quality servo.

Ball bearings and 90 inch ounces of torque!

This is a standard sized servo. It is digital, so it has tremendous holding torque.

Use for throttle servo on gas boats, or rudder servo on smaller boats to about 32 inches.

Extra long 12 inch HD servo wire!


  • Digital High torque ball bearing servo
  • Servo arm set
  • Servo horn screw
  • Servo attachment screws
  • Rubber grommets
  • Brass bushings
  • "J" connector (Futaba, Hitec, JR, Spectrum, Airtronics Z, HK, FlySky, etc.) 


    1.58x.78x1.49 inches (40x19.8x37.6mm)

    Same size as Hitec 300,400 and 500 series and Futaba 3000 series.

    Uses Futaba servo arms.
    See our HD Servo Arm Sets

    Torque- 80 inch/ounces 4.8 volts
                  90 inch/ounces 6.0 volts

    Speed- .16 sec.- 4.8v   .14 sec.-6.0v 

    Weight- 39 grams (1.4 ounce)


  • Model: 5003
  • Shipping Weight: 0.3 lbs
  • 99 Units in Stock

Ask a Question

$16.00 $12.00Save: 25% off

Add to Cart:

This product was added to our catalog on Tuesday 30 October, 2012.