NEW! High quality waterproof metal gear digital servo.
Ball bearings and up to 280 inch ounces of torque!
This is a standard sized servo. It is digital, so it has tremendous holding torque.
Use for throttle servo on gas boats, or rudder servo on smaller boats to about 32 inches.
Extra long 12 inch HD servo wire!
- Digital High torque MG ball bearing servo
- Servo arm set with metal arm
- Servo horn screw
- Servo attachment screws
- Rubber grommets
- Brass bushings
- "J" connector (Futaba, Hitec, JR, Spectrum, Airtronics Z, HK, FlySky, etc.)
1.58x.78x1.49 inches (40x19.8x37.6mm)
Same size as Hitec 300,400 and 500 series and Futaba 3000 series.
Uses Futaba servo arms. See our HD Servo Arm Sets
Torque- 160 inch/ounces 4.8 volts
280 inch/ounces 6.8 volts
Speed- .16 sec.- 4.8v .14 sec.-6.0v
Weight- 68 grams (2.4 ounce)