45GT Outrigger Hydro Short Kit

larger image

This is the new 45GT short kit.

New, Martin Truex designed longer tub and different sponsons for a better ride in rough water.

New World Record Holder!

This hull is the current state of the art for riggers.

Designed for very low hydrodynamic drag with water shearing
and anti capillary features, this hull is fast, and turns are incredible!

You can use any .40-.46 marine engine.

This is considered a short kit, as it only includes Laser cut
wood and foam. No boom tubes, turn fin, engine, radio, hardware, etc.

Included in this short kit:

Laser cut 1/8 ply inner tub sides
Laser cut 1/16 ply outer tub sides
Laser cut 1/16 ply tub top and bottoms w/radio box lid
Laser cut 1/8 ply bulkheads
Laser cut 1/16 ply sponson plates
Laser cut 1/16 ply sponson sheeting
Laser cut 1/8 ply turn fin doubler
Laser cut 1/8 ply ski sides
Laser cut 1/16 ply ski bottom
Laser cut 1/8 ply tub nose
Laser cut 1/16 ply radio box "lips"
Laser cut Foam Sponson cores
Pine tub nose block
Pine sponson nose blocks

Tub is 36 inches long
Tub inside: 3.2 inches wide by 1.5 inches high

No instructions are provided with this kit, as it is intended for
experienced builders.
There are quite a few forum threads on this hull, and you should visit
the International Waters forum for up to date information and tips.

Here is a link to the International Waters Forum

Fiberglass cowlings are now available HERE

Recommended hardware:

Strut
Rudder
Boom Tubes
Turn Fin
Sponson Sleeves
Boom Tube Collars
Shaft Tube
Flex Shaft
Drive Dog
Prop Nuts