This is the new G30 Outboard Tunnel hull from Rod Geraghty and the JAE gang.
Designed for Nitro or Electric power, this new kit features foam core sponsons and quick assembly.
The G30 has been developed to a high level with stock 3.5 nitro and P limited electric power.
Use any 3.5 (.21) outboard. The transom is drilled for the OS lower unit.
You can build this boat in a weekend, ready for sealing.
Specs:
Length- 30.5 inches
Beam- 11.5 inches
Weight- (bare hull) 32 ounces
Kit includes:
Laser cut 1/8 and 1/16 ply for entire boat
2x Foam cores for sponsons
Engine mounting screws
Sponson nose blocks
Balsa fuselage nose block
Lightweight PETG (plastic) cowling (optional Fiberglass or blem fiberglass)
Step by step illustrated building and setup manual
Required for nitro version:
3.5cc Nitro outboard
2 channel radio
90 oz/in standard servo for steering (waterproof is best)
Mini servos for throttle and mixture
8 ounce fuel tank and fuel line
Steering cables or pushrod (and servo mount)
440 prop (Zipp 4007)
Required for FE version:
3.5cc outboard lower unit
2 channel radio
90 oz/in standard servo for steering (waterproof is best)
36mm motor with water jacket ( Zipp 635 and 709)
150A speed control (Zipp 705)
4S 5000 mah battery (60C or higher)
4014/3 prop (Zipp 4031)
Servo mount (Zipp 3711)
Pushrod and connectors
Both require glue, sealer and paint
We recommend medium CA for the fuselage, 30 minute epoxy for sponson assembly and epoxy finishing resin for sealing
We have an Electric Ultimate Hardware Set available that includes everything except radio, lower unit and battery.
We also have a Basic Hardware Set available.
You can save money and add a Zippcut foam cutting system for only $10 more
If you need a lower unit, you can't beat the OS lower.
Add our OS Electric Conversion Set and you are ready.
We now offer 2 different boats; Nitro or Electric.
The difference is the sponson bottoms and fuel tank tray on the nitro version. Please choose the version you want.
Note: Blem fiberglass cowling has minor surface defects like holes or craters in the outer layer. Use polyester filler (Bondo) to fill.
